How to install ceramic wall tile, Tips to Decorating ceramic wall tile, Ceramics installing Idea, Step installing ceramic wall tile

July 8, 2008

Apart from wall cover, plywood, and the plank, the ceramics could then be the wall layer. Not only for the bathroom, also for the wall of the bedroom, the lounge room, and other space. The wall ceramics no longer is plain like that often was encountered by us in the bathroom.
Apart from that was plain that, currently had the purposeful wall ceramics of wood, bamboo, the flower, or the sketch of cement plaster.
These wall ceramics could be used to polish the wall of space apart from the bathroom. The process of the ceramic fitting for the bathroom and other space actually was just the same. That most must be paid attention to was the power glued the ceramics to the wall.
The ceramics must glue strong in order to be not easy to fall. So had the special trick. Take note the analysis along with! The implement and materials Ceramics wall tile of the motive of wood, cement, sand, and water. Water jet, the mallet, rubber float, the bucket, and the sponge. Step Installing ceramics wall tile.

step 1. Checked the surface of the wall.
Immediately tidy up if the face of the wall was not level.
After level, cleaned the surface of the wall with water jet to clean various waste sorts that possibly reduced the power glued the ceramics to the wall.

Step 2. Soak the ceramics in clean water, minimal 30 minutes. Dry with the position stood.

Step 3. The thin layer of the surface of the wall with the cement mixture and sand. Thickly the layer 0,5-1cm. Use the mixture of sand cement with the composition cement-sand 1:2. Added adhesive if necessary. Let while 1 day through to the layer hardened.

Step 4. For the ceramic fitting, screed must be wetted with water.
These efforts to minimize the contraction during the process of drainage.

Step 5. Put on the ceramics to the wall.
polish the mixture of sand cement to the back of the ceramics.
After that put on the ceramics to the wall one by one, was begun from beneath above.

Step 6. Knock on xOBJ with the hammer, so that his underside adheres good to the wall. Use the hammer to arrange the level of the surface between the ceramics, so as level.

Step 7. After being installed three hours, cleaned the surface of the ceramics used the wet sponge.

Step 8.After the ceramics was installed (minimal 24 hours), carried out the filling line of ceramics. Use the mixture cement-sand soft with the composition 2:1. Used rubber float to get the surface